Linear Power Supply for Auralic Aries Mini

New product

£235.00

点击 关闭

Add to wishlist

Customer ratings and reviews

Nobody has posted a review yet
in this language

Rate / write a comment

The MCRU | Longdog Audio fully regulated linear power supplies are multi award winning designs which offer instant sonic up-grades proven by 100's of existing users. ALL the designs we have submitted for review have received top marks. UK designed and built, the only power supply that can be up-graded and built to your own individual specification via our on line menu system.

This model outputs 15V DC to power the Auralic Aries Mini streaming node.

All power supplies come as standard with a power cord to suit your country, 230V or 120V AC input, plug and play design.

DO NOT BE FOOLED INTO PURCHASING A CHEAP CHINESE LINEAR POWER SUPPLY, buy British!

..............................................................................................................................................................

Some words about the design from owner and founder of Longdog Audio Nick Gorham...

When thinking of regulation, it’s worth remembering the Roman god Janus. Who was the god of gateways, and was a two faced god looking in both directions. Likewise a good voltage regulator is required to look in both directions at once. From one direction you have the mains supply, with the ever increasing noise, distortion and random variation that exists on our household mains supply. In the other direction you have the device you are supplying power to. The load will be asking constantly varying current, and the job of the regulator will be to ignore the varying load and to supply a rock steady voltage that ignores the changing load.

To ask a single regulator to perform both tasks means that it can not do either as well as it could. We don’t ask our regulators to be two faced, we split the two functions into two separate regulators and put them both where they can do the best job.

The first regulator is close to the mains supply, its job is to take the incoming mains and convert it into a low(ish) noise DC supply, and to isolate the mess that is our household power lines from what follows. In most power supplies on the market, the output of the first stage would be directly connected to the load device, and that would certainly be an improvement over the supplies that most manufactures provide. But we can do better by adding the other face of Janus to the system.

The second regulator is supplied with a clean low noise supply, and its job is to handle the changing demands of the load. To do that, it needs to be as close to the load as possible. So we remove the second regulator from the main box, and place it close to the load, both electrically and physically, that removes it from the noise and interference of the mains supply, and allows it to spend its time looking towards the load. Typical commercial voltage regulator chips are general purpose devices, but are not quiet enough for the task on hand, so the second regulator uses a bespoke regulator based on a low noise multi stage filtered voltage reference, a low noise error amplifier and a high current low resistance mosfet. To allow it to handle the changing load it also needs to supply current on demand, so all the remaining space in the second regulator is filled with low impedance capacitors to act as a local energy source.

Using the two stages of regulator, we achieve a noise floor equal or better than most battery supplies, and a effective source resistance of the order of 0.02 ohm (and the short cable run to the load avoids increasing this valve by adding copper where its not needed, and the use of a discrete regulator design allows that tiny value to be maintained way above frequency any audio device operates at.

Questions (0)

No customer questions for the moment.

Your Question has been successfully sent our team. Thanks for question!
Ask a question
hide form
Name:
Email:
Question:
  Ask a question

Reviews

Be the first to write your review !